LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Hoses >> Installation (Rear Hoses)

Installation (Rear Hoses)

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear brake hose to the vehicle. Connect the rear brake pipes on the axle to the brake hose. Tighten the rear brake pipes to the brake hose to specification. See TORQUE SPECIFICATIONS  .
  2. Install the retaining bolt of the rear brake hose to the rear axle. Tighten the retaining bolt of the rear brake hose to specification. See TORQUE SPECIFICATIONS  .
  3. Install the retaining nut and retaining clip to the front of the rear brake hose. Connect the rear brake pipe to the brake hose. Bleed the brake hydraulic system. See BLEEDING, FILLING & FLUSHING BRAKE SYSTEM  .
scientia non olet · About LEMON Manuals