LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Anti-Lock Brake System - 4WAL) >> Symptom Tests >> Test A: Abs Indicator Always On

Test A: Abs Indicator Always On

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2001 GMC Savana Special, 2001 GMC Savana Camper Special, 2001 GMC Savana, 2001 Chevrolet Chevy Express, and 2000 GMC Savana Special. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform diagnostic system check. See DIAGNOSTIC SYSTEM CHECK  under DIAGNOSIS & TESTING. After performing diagnostic system check, go to next step.
  2. Turn ignition off for 5 seconds. Turn ignition on while observing the ABS indicator light. If ABS indicator illuminates for 2 seconds then turns off, problem is intermittent. If ABS indicator does not illuminate for 2 seconds or does not turn off, go to next step.
  3. Turn ignition off. Disconnect EBCM 10-pin harness connector. Turn ignition on. If ABS indicator illuminates, go to next step. If ABS indicator does not illuminate, go to step  7 .
  4. Turn ignition off. Disconnect instrument panel cluster harness connector. Connect a test light between ignition 1 voltage circuit and ABS indicator failure control circuit. Turn ignition on. If test light illuminates, go to next step. If test light does not illuminate, go to step  6 .
  5. Repair short to ground in ABS indicator failure control circuit. After repairs, go to step  8 .
  6. Replace instrument panel cluster. After replacing cluster, go to step  8 .
  7. Replace EBCM and perform tire size calibration procedure using scan tool. After replacing EBCM, go to next step.
  8. Turn ignition off for 5 seconds. Turn ignition on while observing ABS indicator light. If ABS indicator light illuminate for 2 seconds then turns off, system is okay. If ABS indicator light does not illuminate, go to step  3 .