LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 598 (Engine Mechanical - 3.8L (On-Vehicle)) >> Repair Instructions >> Fuel Injector Sight Shield Replacement (L36) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the tube/oil fill cap from the valve rocker arm cover.
  2. Insert the tab of the fuel injector sight shield under the engine bracket.
  3. Place the hole of the fuel injector sight shield onto the oil fill neck of the valve rocker arm cover.
  4. Install the tube/oil fill cap into the valve rocker arm cover and twist clockwise in order to lock the detent on the tube into the notch in the cover.
    Fig 1: Tube/Oil Fill Cap In The Valve Rocker Arm Cover
    G01764026Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals