LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 598 (Engine Mechanical - 3.8L (On-Vehicle)) >> Repair Instructions >> Engine Oil Pressure Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine oil pressure sensor.

    Tighten: 

    Tighten the engine oil pressure sensor to 16 N.m (12 lb ft) 

  2. Connect the engine oil pressure sensor electrical connector.
  3. Lower the vehicle.
  4. Check and fill the crankcase as necessary. Refer to Engine Oil and Oil Filter Replacement 
scientia non olet · About LEMON Manuals