Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.

Install the upper engine mount strut bracket.
Install the upper engine mount strut bracket bolts.
Tighten:

Tighten the upper engine mount strut bracket bolts to 50 N.m (37 lb ft)
Install the fuel rail assembly. Refer to FUEL RAIL & INJECTORS
Install the EVAP emissions canister purge valve. Refer to EVAP CANISTER PURGE SOLENOID
Install the lower engine mount strut bracket, bolts and nut.
- Tighten the lower engine mount strut bracket nut.
  Tighten:
  
  Tighten the lower engine mount strut bracket nut to 30 N.m (22 lb ft)
- Tighten the lower engine mount strut bracket bolts.
  Tighten:
  
  Tighten the lower engine mount strut bracket bolts to 50 N.m (37 lb ft)
  
  Fig 1: Lower Engine Mount Strut Bracket Bolts
  Courtesy of GENERAL MOTORS CORP.
Install the right engine mount strut to the upper engine mount strut bracket. Refer to Engine Mount Strut Replacement - Right

Fig 2: Right Engine Mount Strut To The Upper Engine Mount Strut Bracket

Courtesy of GENERAL MOTORS CORP.

Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L36) or Fuel Injector Sight Shield Replacement (L67)
Connect the negative battery cable.