LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 598 (Engine Mechanical - 3.8L (On-Vehicle)) >> Repair Instructions >> Crankshaft Balancer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the drive belt. Refer to Drive Belt Replacement (L36)  or Drive Belt Replacement (L67) 
  3. Raise and support the vehicle.
  4. Remove the right front tire and wheel.
  5. Remove the right engine splash shield.
  6. Remove the torque converter cover. Refer to TORQUE CONVERTER COVER REPLACEMENT in AUTOMATIC TRANSAXLE-4T65-E .
    Fig 1: Right Engine Splash Shield
    G01764196Courtesy of GENERAL MOTORS CORP.
  7. Install the J 37096 to hold the flywheel.
    Fig 2: Install The J 37096 To Hold The Flywheel
    G01764197Courtesy of GENERAL MOTORS CORP.
  8. Remove the crankshaft balancer retaining bolt.

    Important:  Do not separate the crankshaft pulley from the crankshaft balancer. Service the crankshaft pulley and the crankshaft balancer as an assembly.

    Fig 3: Crankshaft Balancer Retaining Bolt
    G01764198Courtesy of GENERAL MOTORS CORP.
  9. Install the J 38197-A.
  10. Remove the crankshaft balancer.
  11. Remove the J 38197-A.
    Fig 4: Crankshaft Balancer
    G01764199Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals