LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 597 (Engine Mechanical - 3.1L V6 - VIN (J) Unit Repair) >> Repair Instructions >> Valve Rocker Arm and Push Rod Removal

Valve Rocker Arm and Push Rod Removal

WARNING: This page is about a different car, the 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the valve rocker arm bolts.
    NOTE: Place the valve train components in a rack in order to ensure that the components are installed in the same location from which they were removed.
  2. Remove the valve rocker arms.
    Fig 1: Valve Rocker Arms
    G01763745Courtesy of GENERAL MOTORS CORP.
  3. Remove the push rods.
    • The intake push rods measure 146 mm (5.75 in).
    • The exhaust push rods measure 152.51 mm (6.0 in).
    Fig 2: Push Rods
    G01763746Courtesy of GENERAL MOTORS CORP.
  4. Remove the intake manifold gaskets.
    Fig 3: Intake Manifold Gaskets
    G01763747Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals