LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 597 (Engine Mechanical - 3.1L V6 - VIN (J) Unit Repair) >> Repair Instructions >> Oil Pan Cleaning and Inspection

Oil Pan Cleaning and Inspection

WARNING: This page is about a different car, the 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the oil level sensor bolt.
  2. Remove the oil level sensor.
  3. Clean the oil pan in solvent. Remove all sludge and debris from the bottom of the oil pan.
  4. Inspect the oil pan sealing surfaces for damage. Replace the oil pan if necessary.
  5. Install the oil level sensor.
  6. Install the oil level sensor bolt.

    Tighten: 

    Tighten the oil level sensor bolt to 10 N.m (89 lb in) 

    Fig 1: Oil Pan
    G01763876Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals