LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 595 (Wheel Alignment Specifications & Adjustment Procedures) >> Repair Instructions >> Rear Camber Adjustment >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle and provide suitable support.
  2. Remove the tire and wheel assemblies. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  3. Remove the strut from the vehicle. Refer to STRUT ASSEMBLY REPLACEMENT .
  4. Place the strut in a vise and file the upper strut-to-knuckle hole lateral (oblong). Compare the appearance of the holes before filing (2) with after filing (3).
    Fig 1: Filing Rear Strut Holes
    G01720499Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals