LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 595 (Wheel Alignment Specifications & Adjustment Procedures) >> Repair Instructions >> Rear Camber Adjustment >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the strut to the vehicle. Refer to STRUT ASSEMBLY REPLACEMENT .

    Tighten: 

    Tighten the strut-to-knuckle bolts as far as to allow movement of the knuckle 

  2. Install the tire and wheel assemblies. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  3. Adjust the camber (1).

    Tighten: 

    Tighten the strut-to-knuckle bolts to 122 N.m (90 ft lbs). 

    Fig 1: Adjusting Rear Camber
    G01720500Courtesy of GENERAL MOTORS CORP.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals