Ignition and Key Alarm Switch Assembly - Disassemble - Off Vehicle (Floor Shift)

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Remove the upper and lower trim covers. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle (Column Shift) or Steering Column Trim Covers - Disassemble - Off Vehicle (Floor Shift) .
Remove the wire harness strap (2) from the steering column and the wire harness assembly (1).

Fig 1: Wire Harness Assembly
Courtesy of GENERAL MOTORS CORP.
Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).

Fig 2: Turn Signal And Multifunction Switch Assembly Connectors
Courtesy of GENERAL MOTORS CORP.
Remove the key alarm connector (1) from the electronic lock module assembly (2).
1. 4.1. Rotate the key alarm connector (1) 90 degrees.
2. 4.2. Pull the key alarm connector (1) out of the electronic lock module assembly (2).
Fig 3: Key Alarm Connector To The Electronic Lock Module Assembly
Courtesy of GENERAL MOTORS CORP.
Remove the connector (2) from the electric park lock (3).
Remove the TORX® head screw (1) from the electric park lock (3).

Fig 4: Connector And Electric Park Lock
Courtesy of GENERAL MOTORS CORP.
Remove the 2 tapping screws (2) from the ignition and key alarm switch assembly (1).
Remove the ignition and key alarm switch assembly (1) from the electronic lock module assembly.

Fig 5: Tapping Screws To The Ignition And Key Alarm Switch Assembly

Courtesy of GENERAL MOTORS CORP.