LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Automatic Transmission Diagnosis - 4L80-E) >> Removal & Installation >> Transmission Internal Wiring Harness >> Removal

Transmission Internal Wiring Harness: Removal

WARNING: This page is about a different car, the 2002 GMC Yukon XL, 2002 GMC Sierra, 2002 Chevrolet Suburban, and 2002 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove transmission oil pan. See appropriate AUTOMATIC article in TRANSMISSION SERVICING.
  2. Disconnect the wire harness connectors from the electrical components.
  3. Remove the transmission wiring harness assembly from the wiring harness clamps.
    4. NOTE: If the transmission wiring harness assembly does not need servicing, do not remove the assembly from the case. Excessive force may damage the pass-through connector.
  4. Remove the transmission wiring harness assembly from the case. Use a 1-5/16" 12-point socket to release the pass-through connector retaining clips from the case.
scientia non olet · About LEMON Manuals