LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Automatic Transmission Diagnosis - 4L80-E) >> Removal & Installation >> Shift Lever Replacement - On Vehicle With Tow/Haul Switch >> Removal

Shift Lever Replacement - On Vehicle With Tow/Haul Switch: Removal

WARNING: This page is about a different car, the 2002 GMC Yukon XL, 2002 GMC Sierra, 2002 Chevrolet Suburban, and 2002 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 2 Torx® head screws from the lower column cover.
  2. Remove the lower column cover.
  3. Roll back the seal on the shift lever (1) until the Torx® head screw (2) is exposed. See Figure.
  4. Remove the Torx® head screw (2). See Figure.
  5. Remove the knee bolster.
  6. Remove the nuts (1) from the knee bolster deflector bracket. See Figure.
    7. NOTE: During removal of the steering column, the wire harness retaining clip must be removed and reinstalled after installing the steering column, or damage may occur to the wire harness.
  7. Remove the wiring harness retaining pin (4) from the instrument panel. See Figure.
  8. Remove the wire straps and open the harness insulation to gain access to the electrical wiring.
  9. Remove the wiring from the electrical connector.
  10. Remove the shift lever.
scientia non olet · About LEMON Manuals