LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 589 (Engine Mechanical - 2.2L) >> Removal And Installation >> In-Vehicle >> Rear Main Oil Seal Replacement - L61 >> Installation

Rear Main Oil Seal Replacement - L61: Installation

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure rear main seal bore is free from debris. If sealer is present, it must be removed to assure proper installation of rear main seal.
  2. Using Rear Crankshaft Seal Installer J42067, press new seal into housing until fully seated. Installer will control depth of seal installation.
    Fig 1: Installing Rear Crankshaft Seal
    G01039481Courtesy of GENERAL MOTORS CORP.
  3. Install flywheel/flexplate.
    Fig 2: Installing Flywheel/Flexplate
    G01039482Courtesy of GENERAL MOTORS CORP.
  4. Install new flywheel/flexplate bolts.
    Fig 3: Installing New Flywheel/Flexplate Bolt
    G01039483Courtesy of GENERAL MOTORS CORP.
  5. Install Flywheel Holder Tool J43653.
  6. Tighten flywheel bolts.

    Torque: 

    Flywheel Bolts - L61: 53 N.m (39 ft-lbs) + 25° 

  7. Remove Flywheel Holding tool J43653.
  8. If vehicle is equipped with a manual transaxle. Install clutch assembly. Refer to TRANSAXLE ASSEMBLY .
  9. Install transaxle assembly. Refer to REMOVAL & INSTALLATION - A/T (VT25-E) and/or REMOVAL & INSTALLATION - A/T (AF33-5) .
scientia non olet · About LEMON Manuals