LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 589 (Engine Mechanical - 2.2L) >> Removal And Installation >> In-Vehicle >> Engine Drive Belt And TENSIONER Replacement >> Installation

Engine Drive Belt And TENSIONER Replacement: Installation

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install tensioner assembly and bolt (if removed).

    Torque: 

    Drive Belt Tensioner Bolt: 45 N.m (33) ft-lbs) 

  2. Route belt around alternator and A/C compressor
  3. Install J-39914 Accessory Drive Belt Tool onto tensioner and unload spring tension from tensioner while positioning the belt.
    Fig 1: Installing Accessory Drive Belt Tool
    G01039282Courtesy of GENERAL MOTORS CORP.
  4. Release tensioner and remove tool.
  5. Install right engine inner splash shield.
  6. Install right wheel and hand tighten wheel nuts.
  7. Lower vehicle.

    Torque: 

    Wheel Nuts: 125 N.m (92 ft-lbs) 

  8. Connect negative battery cable.

    Torque: 

    Battery Terminal Bolt: 17 N.m (13 ft-lbs) 

scientia non olet · About LEMON Manuals