Cylinder Block

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

CYLINDER BLOCK ⁽¹⁾

Application

In. (mm)

Cylinder Bore

Diameter

3.3855-3.3861 (85.992-86.008)

Maximum Taper

.0004 (.010)

Maximum Out-Of-Round

.0004 (.010)

Maximum Piston Height (Below Deck Surface)

.035 (.90)

Maximum Deck Warpage ⁽²⁾

.010 (.254)

⁽¹⁾	For balance shaft bearing specifications, see BALANCE SHAFT & BALANCE SHAFT DRIVE table.

⁽²⁾	Cylinder block may not be machined more than .010 in. (.254 mm). If block requires more than allowable machining to obtain required flat surface, replace engine block.