LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 586 (Air Bag System) >> Removal & Installation >> Instrument Cluster >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. If replacing instrument cluster, perform configuration procedure. See IMMOBILIZER RESETTING PROCEDURE  . Disconnect negative battery cable.
  2. Remove left front door scuff plate and left front side trim panel. Pull out hood release lever and, using screwdriver, release retaining tab and remove hood release lever from lower panel. Remove screw and pull lower panel outward to release clips. Disconnect light control switch and headlight leveling switch connectors, and remove lower panel.
  3. Detach meter hood rubber from upper column cover. Pull meter hood outward, detach tabs and locator pins and remove meter hood. Remove screws and pull instrument cluster outward. See Figure . Disconnect electrical connectors and carefully remove instrument cluster.
  4. To install, reverse removal procedure. If instrument cluster has been replaced, perform immobilizer resetting procedure. See IMMOBILIZER RESETTING PROCEDURE  .
scientia non olet · About LEMON Manuals