LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 585 (Rear Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a replacement stud in the wheel hub.
  2. Add enough washers in order to draw the stud into the hub.
  3. Install the wheel nut with the flat side against the washers.
    4. NOTE: Fully seat the wheel stud against the hub flange.
  4. Tighten the wheel nut until the wheel stud is fully seated against the hub flange.
  5. Back off the wheel nut and remove the washers. Install the backing plate.
  6. Install the backing plate.
  7. Install the rear wheel bearing/hub assembly.
  8. Install the tire and wheel assembly.
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals