Removal Procedure (Drum Brakes)

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The wheel bearing in the rear wheel hub is integrated into one unit. The hub is non-serviceable. If the hub and/or bearing is damaged, replace the complete hub and bearing assembly.

Raise and suitably support the vehicle.
Remove the brake drum. Refer to BRAKE DRUM .
Disconnect the ABS electrical connector from the wheel speed sensor, if equipped.

Fig 1: Locating ABS Electrical Connector At Wheel Speed Sensor (Drum Brakes)
Courtesy of GENERAL MOTORS CORP.
Remove the bearing/hub mounting bolts.

Fig 2: Wheel Bearing/Hub Mounting Bolts (Drum Brakes)
Courtesy of GENERAL MOTORS CORP.
Remove the bearing/hub from the vehicle.