LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 585 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer shaft link (1) to the vehicle.
  2. Connect the stabilizer shaft link (1) to the stabilizer shaft (2).
    3. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the stabilizer shaft link nut to the stabilizer shaft link (1) and the stabilizer shaft (2). Tighten the nut to 52 N.m (38 ft lbs).
  4. Connect the stabilizer shaft link (1) to the strut.
  5. Install the stabilizer shaft link nut to the stabilizer shaft link (1) and the strut. Tighten the nut to 52 N.m (38 ft lbs).
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals