LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 583 (Rear Suspension System) >> Repair Instructions >> Wheel Stud >> Installation

Wheel Stud: Installation

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a replacement stud in the wheel hub.
  2. Add enough washers in order to draw the stud into the hub.
    Fig 1: Installing Stud
    G00357941Courtesy of GENERAL MOTORS CORP.
  3. Install the wheel nut with the flat side against the washers.
    4. NOTE: Fully seat the wheel stud against the hub flange.
  4. Tighten the wheel nut until the wheel stud is fully seated against the hub flange.
  5. Back off the wheel nut and remove the washers.
  6. Install the backing plate. See REAR DISC BRAKE BACKING PLATE .
  7. Install the rear wheel bearing/hub assembly. See WHEEL BEARING/HUB (REAR) .
  8. Install the tire and wheel assembly.
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals