LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 583 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft >> Installation

Stabilizer Shaft: Installation

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer shaft to the rear suspension support. See Figure.
  2. Install the stabilizer shaft insulator brackets and hand tighten the bolts. Do not tighten the bolts at this time.
  3. Install the right and left stabilizer shaft link nuts to the stabilizer shaft links. See Figure.
    • Tighten the stabilizer shaft link nuts to 52 N.m (38 lb ft).
    • Tighten the stabilizer shaft insulator bracket nuts to 48 N.m (35 lb ft).
  4. Install the tires and wheels.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals