LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 583 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link >> Installation

Stabilizer Shaft Link: Installation

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer shaft link to the vehicle. See Figure.
  2. Connect the stabilizer shaft link to the stabilizer shaft.
  3. Install the stabilizer shaft link nut to the stabilizer shaft link and the stabilizer shaft. Tighten the nut to 52 N.m (38 lb ft).
  4. Connect the stabilizer shaft link to the strut. See Figure.
  5. Install the stabilizer shaft link nut to the stabilizer shaft link and the strut. Tighten the nut to 52 N.m (38 lb ft).
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals