Wheel Bearings Diagnosis
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Tools Required: (J-8001) Dial Indicator Set.
- Raise and support the vehicle.
- Mount and secure the J 8001 to a stand.
- Ensure that the J 8001 contacts the vertical surface of the wheel as close as possible to the top wheel stud. See Fig 1 .
- Push and pull on the TOP of the tire.
- Inspect the total movement indicated by the J 8001.
- If the measurement exceeds 0.127 mm (0.005 in), replace the wheel bearing/hub. Refer to Wheel Bearing/Hub Replacement - Front in Front Suspension.
NOTE:
If you are inspecting the FRONT wheel bearing/hub, support the front of the vehicle by the lower control arms in order to load the lower ball joint.