LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 580 (Rear Suspension System) >> Repair Instructions >> Shock Absorber Replacement (All Wheel Drive) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Use a utility stand in order to slightly compress the coil spring and relieve tension on the shock absorber. See Figure.
  3. If the vehicle is equipped with automatic level control, disconnect the air tube connector from the shock absorber.
  4. Remove the shock absorber upper bolt.
  5. Remove the shock absorber lower nut.
  6. Remove the shock absorber.
scientia non olet · About LEMON Manuals