LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 580 (Rear Suspension System) >> Repair Instructions >> Shock Absorber Replacement (All Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shock absorber.
  2. Install the shock absorber upper bolt. Tighten the shock absorber bolt to 85 N.m (63 lb ft).
  3. Install the shock absorber lower nut. Tighten the shock absorber nut to 85 N.m (63 lb ft).
  4. If the vehicle is equipped with automatic level control, install the air tube connector to the shock absorber.
  5. Remove the utility stand.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals