LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 580 (Rear Suspension System) >> Repair Instructions >> Rear Wheel Bearing/Hub Replacement (Fwd - Drum) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the tire and wheel.
  3. Remove the brake drum. Refer to Brake Drum Replacement in Drum Brakes .
  4. Remove and discard the wheel bearing/hub bolts.
    Fig 1: Removing Wheel Bearing/Hub
    G00357850Courtesy of GENERAL MOTORS CORP.
  5. Remove the wheel bearing/hub.
  6. Disconnect the wheel speed sensor electrical connector (2).
    Fig 2: Removing Wheel Speed Sensor
    G00379260Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals