Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Align the flat edge of the bushing with the mark on the control arm in order to install the bushing at a 45 degree angle.

Fig 1: Aligning Flat Edge Of Bushing With Mark On Control Arm
Courtesy of GENERAL MOTORS CORP.
Use J 28685 and J 9519-E in order to install the control arm bushing.

NOTE: The bushing must extend 9.8 mm (0.39 in) from the control arm.

Fig 2: Installing Bushing To Proper Depth

Courtesy of GENERAL MOTORS CORP.

The bushing is installed to the proper depth when the end of the bushing is aligned with the indicator line on J 28685.
Use the utility stand in order to raise the rear axle.
Install the control arm bolt to the rear axle.
Remove the utility stand.
Lower the vehicle.