Removal Procedure
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle.
- Use the utility stand in order to support the center of the rear axle.
- Remove the shock absorber lower bolts and nuts.
- Remove the rear axle tie rod from the rear axle.
- Use the utility stand in order to lower the rear axle.
- Remove the springs (4) and the insulators (5). See Fig 1.
NOTE:
Do not suspend the rear axle by the brake hoses. Damage to the brake hoses may result.
NOTE:
Care should be taken to avoid chipping or scratching the coating when handling the suspension coil spring. Damage to the coating can cause premature failure.