Z Height Adjustment
WARNING: This page is about a different car, the 2002 Cadillac Escalade EXT and 2002 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
- For vehicles equipped with a torsion bar suspension turn the bolt (1) that contacts the torsion arm as needed. One revolution of the bolt (1) into the nut increases the Z height by approximately 6.0 mm (0.2 in).
- For vehicles without torsion bars, replace damaged or worn components as necessary.
- If these measurements are still out of specifications after adjustment or are not equipped with torsion bars, inspect for sagging front suspension or collision damage.