Rear Shock Absorber Disposal
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Place the shock absorber on a level surface or with the piston pointing downwards.
- Drill a 2-3 mm {0.08-0.11 in} hole at the point "A" shown in the figure so that the gas can escape.
- Drill a 2-3 mm {0.08-0.11 in} hole at the point "B" shown in the figure to drain the oil.
- Turn the hole made in step 3 downwards and drain the oil by pumping the piston rod up and down several times.
- Cut off the end of the shock absorber.
- Dispose of waste oil according to local waste disposal laws.
WARNING:
Whenever drilling into a shock absorber, wear protective eye wear. The gas in the shock absorber is pressurized and could spray metal chips into the eyes and face.