LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 578 (Rear Suspension System) >> Rear CROSSMEMBER >> Rear Crossmember Removal/Installation >> Notes

Rear Crossmember Removal/Installation: Notes

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear auto leveling sensor. See AUTO LEVELING SENSOR REMOVAL/INSTALLATION .
  2. Remove the rear stabilizer. See REAR STABILIZER REMOVAL/INSTALLATION .
  3. Remove the charcoal canister. See CHARCOAL CANISTER REMOVAL/INSTALLATION .
  4. Remove in the order indicated. See Fig 1.
  5. Install in the reverse order of removal.
  6. Inspect the wheel alignment and adjust it if necessary. See WHEEL ALIGNMENT .
Fig 1: Crossmember With Torque Specifications
G00376687Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals