LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 577 (Rear Suspension System) >> Repair Instructions >> Wheel Bearing/Hub Replacement - Rear >> Removal

Wheel Bearing/Hub Replacement - Rear: Removal

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Remove the tire and wheel assemblies.
  2. Remove the brake drum. Refer to REAR BRAKE DRUM . Remove the hub and bearing assembly from the axle. The top rear attaching bolt and nut will not clear the brake shoe when removing the hub and bearing assembly. Partially remove the hub and bearing assembly prior to removing this bolt.
  3. Disconnect the rear ABS wheel speed sensor wire connector. Remove the hub and bearing assembly from the vehicle.
scientia non olet · About LEMON Manuals