LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 577 (Rear Suspension System) >> Repair Instructions >> Wheel Bearing/Hub Replacement - Rear >> Installation

Wheel Bearing/Hub Replacement - Rear: Installation

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the rear ABS wheel speed sensor wire connector. Install the hub and bearing assembly. Position the top rear attaching bolt in the hub and bearing assembly prior to the installation in the axle assembly. Tighten the hub bolts to 85 N.m (62 lb ft).
  2. Install the brake drum. Refer to REAR BRAKE DRUM . Install the tires and wheels. Lower the vehicle.
scientia non olet · About LEMON Manuals