Removal & Installation
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Raise and suitably support the vehicle. Remove the stabilizer shaft link bolts. Remove the stabilizer shaft insulator brackets and nuts from the stabilizer shaft. Remove the stabilizer shaft from the vehicle. Install the stabilizer shaft to the vehicle. Install the stabilizer shaft insulator brackets to stabilizer shaft and nuts. Do not tighten the nuts at this time. Install the stabilizer shaft link bolts. Tighten the link bolts to 51 N.m (37 lb ft). Tighten the stabilizer shaft insulator bracket bolts to 53 N.m (39 lb ft). Lower the vehicle.