LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 576 (Suspension System General Diagnosis) >> Diagnostic Information And Procedures >> Trim Height Inspection Procedure >> D Height Dimension Measurement Procedure

D Height Dimension Measurement Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

The D height dimension measurement determines the proper ride height for the rear of the vehicle.

  1. Use your hands in order to lift the rear bumper of the vehicle up approximately 38 mm (1.5 in). Gently remove your hands in order to allow the vehicle to settle.
  2. Use your hands in order to push the rear bumper of the vehicle down approximately 38 mm (1.5 in). Gently remove your hands in order to allow the vehicle to settle.
  3. Measure the D height dimension on the rear suspension for the left and the right side of the vehicle. If the vehicle has FWD measure from the center line of the rear wheel to the center line of the rear axle pivot bolt. If the vehicle has AWD measure from the center line of the rear wheel to the center line of the lower control arm pivot bolt.
  4. Compare the measurement to the specification. Refer to TRIM HEIGHT SPECIFICATIONS .
  5. If the measurement is not within 10 mm (0.4 in) of the specification, replace the rear springs. Refer to COIL SPRING REPLACEMENT - FWD or COIL SPRING REPLACEMENT -- AWD in Rear Suspension.

scientia non olet · About LEMON Manuals