Wheel Bearing/Hub Replacement - Rear (Fwd): Removal

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

If the vehicle has rear disc brakes, remove the rear brake rotor. Refer to REAR BRAKE ROTOR .
If the vehicle has rear drum brakes, remove the brake drum. Refer to BRAKE DRUM .
If the vehicle has ABS, disconnect the rear wheel speed sensor connector (3). Position the connector to the side.

Fig 1: Locating Hub Bearing Bolts & Speed Sensor Connector
Courtesy of GENERAL MOTORS CORP.
Remove the 4 bolts (1,2,4,5).
Remove the wheel bearing and hub assembly.