LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 575 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement - AWD >> Removal

Stabilizer Shaft Replacement - AWD: Removal

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear drive module. Refer to CROSSMEMBER REPLACEMENT - AWD .
  2. Use paint in order to place match marks on the stabilizer shaft insulators (6,13) and on the stabilizer shaft (14).
    Fig 1: Identifying Stabilizer Shaft Components (AWD)
    G00370994Courtesy of GENERAL MOTORS CORP.
  3. Remove the 4 bolts (3,4,8,9).
  4. Remove the 2 stabilizer shaft insulator brackets (5,7).
  5. Remove the 2 stabilizer shaft insulators (6,13).
  6. Remove the 2 nuts (2,10) from the link studs.
  7. Remove the stabilizer shaft from the rear suspension crossmember.
scientia non olet · About LEMON Manuals