LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 575 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement - AWD >> Installation

Stabilizer Shaft Link Replacement - AWD: Installation

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the link to the stabilizer shaft. See Figure.
  2. Install the link to the knuckle.
    NOTE: Refer to FASTENER NOTICE .
  3. Install the 2 nuts to the link studs. See Figure. Tighten the nuts to 44 N.m (32.5 lb ft).
scientia non olet · About LEMON Manuals