LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 575 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement - AWD >> Installation

Stabilizer Shaft Insulator Replacement - AWD: Installation

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. If you are replacing the insulators (6,13), copy the match marks from the old components to the new components. See Figure.
  2. Align the match marks and install the insulators to the shaft.
  3. Install the brackets to the insulators.
  4. Install the 4 bolts (3,4,8,9) to the brackets. See Figure.
  5. Install the rear drive module. Refer to CROSSMEMBER REPLACEMENT - AWD .
scientia non olet · About LEMON Manuals