LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 573 (Rear Suspension System) >> Repair Instructions >> Tie Rod Replacement (Suspension Link) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in TIRES AND WHEELS article.
  3. Disconnect the outer tie rod end from the suspension knuckle. Refer to TIE ROD REPLACEMENT (OUTER END) .
  4. Remove the nut (1) retaining the rear suspension adjustment link to the crossmember. See Fig 1.
  5. Remove the rear suspension adjustment link (2) from the vehicle.
Fig 1: Removing Rear Suspension Adjustment Link
G00371771Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals