LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 573 (Rear Suspension System) >> Repair Instructions >> Tie Rod Replacement (Outer End) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Tools Required 
  • J 42188 Ball Joint Separator
  1. Raise and support the vehicle.
  2. Remove the tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in TIRES AND WHEELS article.
  3. Loosen, do not remove, the outer tie rod end stud nut (2) from the outer tie rod end ball stud. See Figure.
  4. Install J 42188 between the steering knuckle and the outer tie rod end stud.
  5. Tighten the bolt on J 42188 until the steering knuckle and the outer tie rod end stud separate.
  6. Remove J 42188 and the outer tie rod end stud nut.
  7. Remove the outer tie rod end stud from the suspension knuckle.
  8. Loosen the jam nut (4) on the rear suspension adjustment link. See Fig 1.
  9. Remove the outer tie rod end (3) from the rear suspension adjustment link (1).
Fig 1: Removing Outer Tie Rod End
G00371770Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals