Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the stud into the axle flange.
- Install the 4 washers and the lug nut to the stud.
- Tighten the lug nut in order to draw the stud into the flange until the stud fully seats.
- Remove the lug nut and the washers.
- Install rotor.
- Install the tire and wheel.
- Lower the vehicle.