LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 571 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement (2-Door Utility) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle.
  2. Remove the lower nuts, washers and bolts from the stabilizer links.
    Fig 1: Identifying Rear Stabilizer Link
    G00357818Courtesy of GENERAL MOTORS CORP.
  3. Remove the nuts from the U-bolts and nuts.
    Fig 2: Removing Stabilizer Shaft U-Bolt
    G00357819Courtesy of GENERAL MOTORS CORP.
  4. Remove the U-bolts, clamps and insulators.
  5. Remove the stabilizer shaft.
scientia non olet · About LEMON Manuals