LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 571 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement (4-Door Utility) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle.
  2. Remove the stabilizer shaft link upper nut and bolt.
    Fig 1: Removing Stabilizer Shaft Link Upper Bolt & Nut
    G00357820Courtesy of GENERAL MOTORS CORP.
  3. Remove the stabilizer shaft link lower nut and bolt. See Figure.
  4. Remove the stabilizer shaft link.
scientia non olet · About LEMON Manuals