LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 568 (Rear Suspension) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Installation

Stabilizer Shaft Link Replacement: Installation

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the stabilizer link through the control arm.
    NOTE: Refer to FASTENER NOTICE .
    NOTE: When connecting the stabilizer link, hold the link with a wrench to prevent turning.
  2. Install the stabilizer link to control arm nut. Tighten the nut to 15 N.m (11 lb ft).
    NOTE: Hold the ball shaft secure with a TORX® bit, when installing the nut.
  3. Install the stabilizer link to stabilizer bar nut. Tighten the nut to 63 N.m (46 lb ft).
  4. Install the stabilizer bar clamp bolts. Tighten the bolts to 70 N.m (52 lb ft).
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals