Spring Jounce Bumper Replacement: Installation
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Install the jounce bumper to the lower control arm.
- Hand tighten the jounce bumper nut.
- Install the coil Spring. Refer to COIL SPRING INSULATORS REPLACEMENT .NOTE: Refer to FASTENER NOTICE .
- Tighten the jounce bumper to lower control arm nut. Tighten the nut to 63 N.m (46 lb ft).
- Lower the vehicle.
- Check the rear alignment.
- For 2003 models, refer to SPECIFICATIONS .
- For 2004 models, refer to SPECIFICATIONS .