LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 564 (Engine Mechanical - Overhaul - (LF, L3)) >> Cylinder Block (II) Disassembly >> Connecting Rod Cap Disassembly Note

Connecting Rod Cap Disassembly Note

WARNING: This page does not describe the selected car, but rather 22 other vehicles, including the 2009 Mazda B2300, 2009 Mazda 5, 2008 Mazda Tribute, 2008 Mazda B2300, and 2008 Mazda 5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the connecting rod side clearance. (See CONNECTING ROD INSPECTION .)
    2. NOTE:
    • The tappets are numbered to make sure they are assembled in their original positions. When removed, keep the tappets with the cylinder head they were removed from. Do not mix the tappets.
  2. Remove the connecting rod bolt from the connecting rod cap by tapping the bolt with a plastic hammer.
scientia non olet · About LEMON Manuals