LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 564 (Engine Mechanical - Overhaul - (LF, L3)) >> Cylinder Block (I) Assembly >> Connecting Rod Cap Assembly Note

Connecting Rod Cap Assembly Note

WARNING: This page does not describe the selected car, but rather 22 other vehicles, including the 2009 Mazda B2300, 2009 Mazda 5, 2008 Mazda Tribute, 2008 Mazda B2300, and 2008 Mazda 5. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • When assembling the connecting rod caps, align the broken, rough faces of the connecting rods and connecting rod caps.
  1. Tighten the connecting rod bolts in two steps using the SST (49 D032 316)  .

    Tightening Torque 

    1. (1) 26-32 N.m {2.7-3.2 kgf.m, 19.2-23.6 ft.lbf} 
    2. (2) 80°-100° 

scientia non olet · About LEMON Manuals