LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 562 (Starting System) >> Diagnostic Information & Procedures >> Testing For Intermittent And Poor Connections >> Round Wire Connectors

Round Wire Connectors

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Follow the procedure below to test terminal contact of Metri-Pack or 56 series terminals.

  1. Separate the connector halves.
  2. Visually inspect the connector halves for contamination. Contamination may result in a white or green build-up within the connector body or between terminals. This causes high terminal resistance, intermittent contact, or an open circuit. An underhood or underbody connector that shows signs of contamination should be replaced in its entirety: terminals, seals, and connector body.
  3. Using an equivalent male terminal, test that the retention force is significantly different between a good terminal and a suspect terminal. Replace the female terminal in question.

scientia non olet · About LEMON Manuals